Appendix Carry Plus Magazine Molds

Appendix Carry Plus Magazine Molds

$164.00
Free Shipping!

LEAD TIMES: BETWEEN 2-3 WEEKS AVERAGE

Seconds add up to minutes. Minutes add up to hours. Hours add up to a lot of time and money. Stop wasting your time blocking molds for attachments and laying out drilling points, etc. 

Our molds are modeled with Computer Aided Design technology and are CNC machined. Each mold comes with the controls, ejection port, sight channel, and trigger guard blocked out. Molds are slightly oversized from the actual gun so you won’t need tape for clearance. Unlike HDPE forming molds produced by other manufacturers, this material will allow most tapes and glues to stick so if you wanted a different fit or your own custom blocking you can accommodate that easily. Also this material does not tend to warp or cup like HDPE tends to with heat and repeated use. Trim molds (not subjected to heat) are made of HDPE and save countless hours of drawing and cutting when used correctly. Molds come with a 15 degree draft cut on the edges for easier mold removal.

AIWB Plus Magazine Molds come with built in adjustable retention and pre-set index points for use with Tough Clips/RCS/DIY/ModWing attachment points. The drill index points included will save layout time which easily adds up to several hours of your time per year. Index points are included for drilling eyelet holes as well. These molds will be available without any blocking or index points as well.

Trim molds are made of HDPE and feature a roughly 0.3” - 0.5” vertical sidewall for use with a trim bearing bit on a router table. Trim molds have anchoring points based on the forming molds’ drill index points which help stabilize the holster shell on the trim mold. For safety purposes, padded push blocks and all router table safety mechanisms should always be used when using the trim molds and a router.

Email first for questions about changes. Minor changes may or may not result in increased costs based on the time it takes to make the changes. Custom molds and trim molds are available but only at an increased cost. Unless specifically requested otherwise, the adjustable retention spacing on these molds creates a .25" opening at the muzzle end of the holster to allow debris to be washed out. 

For the drill index points, the hole spacing (15mm/.591”) will accept any of the Raven Concealment components, DIY, Tough Clips, or other hardware with matching spacing such as the ModWing lineup.